FLASH, EPROM & SRAM Emulator FlexROM III ( FR3 ) is a flexible in-circuit memory emulator with instrumentation FR3 increases productivity by downloading firmware code or data into the emulator at 2.5 Mbit per second. Set an Address Trigger, measure the Target's voltage level and see the Target's address fetches with FR3's hardware instrumentation. Adapt easily to new target technologies with FR3's Active Cables

New Features:

• Active Cable Modules (ACM) contain Target interface and Control Logic.
  Active Cables combine the target ELECTRICAL and PHYSICAL interfaces into a low cost, replaceable assembly.
  By simply changing the Active Cable Module, you can reconfigure your FlexROM III to emulate different device configurations, packages or voltage levels. This approach allows you to support multiple target configurations with a single emulator, reducing your initial investment. In addition, your tool investment is preserved.
  
• Provides adaptability to new Target Technologies.
• Hardware Instrumentation
    - Target Voltage Measurement.
    - Address Snap-Shot Circuit.
    - Address Match & Trigger Circuit.
  
• Reverse Voltage Protection.
• Adjustable Timing Parameters
• Integrated Low-Voltage Support.
• External Power Option.
• Jumper-less Address Configuration.
• Up to 256 Mbit/32 MByte Emulation in a single unit.
• Includes QuickLoader Software.