BiPOM Forum

General => GadgetPC => Topic started by: franklin97355 on November 21, 2009, 12:05:25 pm

Title: Pinout for the serial port?
Post by: franklin97355 on November 21, 2009, 12:05:25 pm

I have two questions.
1. where can I find the pinout for the serial port on the GadgetPC?
 and
2. Is it 3.3v or 5v levels?

Title: Re: Pinout for the serial port?
Post by: franklin97355 on November 27, 2009, 11:09:43 am

Vitaliy responded with this:
3.3v (out)
GND
RXD(3.3v in)
TXD(3.3v out)
GND
Not Connected
GND
GND
This is with the four USB ports facing to the right.
Thanks Vitaliy

Title: Re: Pinout for the serial port?
Post by: vitaliy on December 11, 2009, 10:40:52 am

http://www.bipom.com/support/gadgetpc/uart.jpg
(http://www.bipom.com/support/gadgetpc/uart.jpg)

Title: Re: Pinout for the serial port?
Post by: vitaliy on December 24, 2009, 03:16:35 am

The simplest way to get access to a serial console is to use a  BRD-RS232-TTL-1  peripheral board .
http://www.bipom.com/products/us/851715.html
The board will be powered from the GadgetPC if the J8 jumper is closed.
(http://www.bipom.com/support/gadgetpc/serial_console.jpg)

Title: Re: Pinout for the serial port?
Post by: meetseo on December 05, 2011, 09:39:09 am

Hi,

This is really a very nice info. Thanks & keep us updated.

Regards

Title: Re: Pinout for the serial port?
Post by: Ashley on December 08, 2011, 07:16:06 am

I want to know which  any USB Flash Drive i can connect  with GadgetPC ?

Title: Re: Pinout for the serial port?
Post by: vitaliy on December 08, 2011, 10:16:27 am

http://www.bipom.com/documents/boards/gadgetpc/GadgetPC%20Supported%20Hardware.pdf