CART

MINI-MAX/ARM-S

MINI-MAX/ARM-S is a general purpose, low-cost and highly-expandable micro-controller system. It is based on the ATMEL AT91SAM7S256 single-chip Flash micro-controller

$79
MINI-MAX/ARM-S - The micro-controller system based on the ATMEL AT91SAM7S256 single-chip Flash micro-controller
BiPOM Electronics is a proud ATMEL Consultant for ARM ( SAM7, SAM9 and AT91RM9200 ) Family of microcontrollers

The Flash micro-controller can be programmed and debugged through USB or JTAG. Downloading of programs to the micro-controller typically takes few seconds.

MINI-MAX/ARM-S is powered by 5 Volts DC from the USB connector The total current consumption of the board is less than 60mA

Features

  • Up to 55 MIPS program execution speed
  • 256 Kilobytes of In-System Re-programmable Downloadable Flash Memory
  • 64 Kilobytes of RAM
  • 3-channel 16-bit Timer/Counter
  • Programmable 32 bit Watchdog Timer
  • USB 2.0 Full Speed (12 Mbit per Second) Device Port
  • 2 Programmable Enhanced UART Serial Interfaces
  • SPI Serial Interface
  • 2-wire Serial Interface (I2C)
  • Four channel 16-bit PWM controller
  • 8-channel 10-bit ADC with external Reference Voltage input
  • 11-channel DMA controller
  • 32 general purpose I/O pins
  • Real time In-System debug support through JTAG Interface
  • In-circuit Programming and debugging of the micro-controller through the JTAG Interface
  • USB Port for data communications (Device Mode only)
  • Keypad connector
  • LCD connector ( with programmable contrast adjustment for LCD )
  • Screw terminal block for analog circuits
  • Expansion bus interface to low-cost peripheral boards
  • Fully supported in C and ARM Assembly Language using our ARM7 Development System, GNUARM C Compiler and FreeRTOS. Also, supported by IAR Systems Embedded Workbench and J-Link Debugger
  • USB cable, online technical manual and schematics