PCARD-1
Low cost PIC® Programmer
USB Peripheral Boards
Find By Type:
- All
- USB Memory
- USB Data Acquisition (D/A, A/D, Sensors)
- USB Communications
- USB Control
- USB batteries & power supplies
- Breakout Boards
DLP-TEMP-G
DLP-TEMP-G is a microcontroller based 3-channel data-acquisition system preprogrammed with firmware for digital I/O or reading digital temperature-sensing devices. The DLP-TEMP-G board is equipped with a Type A male USB connector for direct connection to a USB port. No cable is required unless the board is to be located away from the PC, in which case a user supplied USB A-A (male-female) extension cable can be used.
Details
DLP-IO8-G
DLP-IO8 Data Acquisition Module is a low-cost, easy-to-use data acquisition system for measuring voltages, controlling and monitoring processes, and acquiring temperature data. Each of the 8 available channels can be configured for any of the digital, analog, or temperature modes via single-byte commands. All operational power is taken from the host PC via the USB port.
Details
DLP-UTH8
DLP-UTH8 is a low-cost, easy-to-use active hub used for connecting multiple temperature and humidity sensors to one PC featuring 4th generation USB silicon from FTDI. All operational power is taken from the host PC via the USB port. The temperature and humidity sensor modules (shown below) connect to the DLP-UTH8 using standard CAT5 ethernet cable.
Details
DLP-RFID1
DLP-RFID1 is a low-cost, USB-powered module for reading from and writing to ISO 15693, ISO 18000-3, and Tag-it™ intelligent RFID transponder tags. It has the ability to both read and write up to 256 bytes of data in addition to reading the unique identifier (UID/SID). All of the DLP-RFID1's electronics and antenna reside within the compact unit, and all operational power is taken from the host PC via the USB interface. The range of the internal antenna is up to 4 inches depending upon the size of the tag being read.
Details
DLP-RF1-Z
The DLP-RF1-Z combines a USB interface, Freescale™ MC13193 2.4GHz Direct-Sequence Spread Spectrum RF Transceiver IC and Freescale MC9S08GT60 microcontroller to form an IEEE 802.15.4 compliant, ZigBee™ ready, short-range transceiver module.
Details
CBL-USB-COM-1
This cable is suitable for adding one RS232 serial port to your computer. It works with both USB 1.X and USB 2.0 ports
Details
BRD-USB-RS232-TTL-1
The USB converts USB to TTL level RS232 signals. Ideal for microcontroller circuits. The design uses FTDI FT232BM/BL chip.
Details
BRD-USBXB-1
It is the most easiest and reliable way to connect the Xbee module to a PC via USB port
Details
DLP-IOR4
The DLP-IOR4 is a low-cost, easy-to-use relay module utilized for computer control of electrical or electronic equipment.
Details
K38021US
Rechargeable battery pack. AC power adapter with USB allows you to recharge your battery pack.
Details
